Sewing
16
5 Sewing
In the sewing mode all relevant adjustments for the sewing operation are shown on the
display and can be altered directly. Functions can be switched on and off by pressing the
key.
In this mode a difference is made between manual sewing and programmed sewing. To
change from manual to programmed sewing, press the PM key. In programmed sewing the
text "PM" appears on the display.
5.01 Manual sewing
After the machine has been switched on, the maximum speed, the puller feed stroke and
the puller pressure can be adjusted with the corresponding +/- keys.
Further functions in manual sewing, also see Chapter 2.02.02Function keys:
Start backtacks on/off Presser foot raised at end of seam on/off
End backtacks on/off Thread trimming on/off
Needle position raised on/off Sensor on/off
Presser foot raised on/off
On the basic machine the stitch length is adjusted with the balance wheel.
The stitch length for the puller is adjusted on the control panel
4000 PUL 30%
2.0mm
Speed
To Next Page
Loading...
Need help?
General
