Pfaff 480 Series

Table of Contents
Contents ...............................................................................Chapter - Page
1 Safety ..................................................................................................... 1- 1
1.01 General notes on safety ............................................................................................ 1 -1
1.02 Safety symbols ......................................................................................................... 1 - 2
1.03 Danger .......................................................................................................................1- 2
2 Adjustment ............................................................................................. 2- 1
2.01 Notes on the service manual .................................................................................... 2 - 1
2.02 Tools, gauges and other accessories........................................................................ 2 - 1
2.03 Abbreviations............................................................................................................. 2 - 1
2.04 Work symbols ........................................................................................................... 2 - 1
2.05 Lateral adjustment of the thread catcher ................................................................. 2 - 2
2.06 Front reversal point of the thread catcher ................................................................ 2 - 3
2.06.01 Setting for -900/97 ..................................................................................................... 2 -3
2.06.02 Setting for -900/99 ..................................................................................................... 2 -4
2.07 Knife to needle clearance (only -900/99) ................................................................... 2 - 5
2.08 Manual trimming control........................................................................................... 2 - 6
2.08.01 Control for -900/97..................................................................................................... 2 -6
2.08.02 Control for -900/99..................................................................................................... 2 -7
2.09 Needle thread tension release................................................................................... 2 - 8
2.10 Air blast dosage (only -900/97).................................................................................. 2 - 9
2.11 Positioner...................................................................................................................2-10
2.12 Mounting and dismounting the control unit .............................................................. 2 - 11
2.13 Parameter settings.................................................................................................... 2 - 12
2.13.01 Parameter list (only -900/97) ..................................................................................... 2 - 12