Pfaff admire 1000 User Manual

1
2
3
4
13
2. GETTING READY TO SEW
Threading your machine
Wrong threading may cause skipped stitches, breaking threads, or
other problems.
Try to master the correct threading before moving on to test sew-
ing.
Threading must be carried out in the sequence of Upper Looper -
Lower Looper - Needle.
Open the front cover and the working table.
Raise needle to its highest point by turning hand wheel towards
you, and raise the presser foot.
Before re-threading the lower looper after a thread break,
remove thread from needle eye first, then re-thread the lower
looper. This will prevent tangling.
1. Feed the thread through the thread guides as illustrated.
2. Pull the upper thread through the slot, holding the thread with
your left hand.
3. Draw the thread through the thread guide as illustrated.
4. Pass the thread through wire thread guide and looper eye, leaving
an excess length of about 4” (10 cm).
Threading upper looper

Pfaff admire 1000 Specifications

General

LED Light	Yes
Free Arm	Yes
Type	Serger
Differential feed	Yes
Built-in rolled hem	Yes
Max Stitch Width	7 mm
Max Stitch Length	4 mm
Speed Control	Foot pedal
Sewing Speed	1300 stitches per minute
Number of threads	4