8
1. Wipe off any excess oil in the needle plate and
bed areas.
2. FOOT CONTROL
Push foot control plug into connector socket,
and connect the power line plug into power sup-
ply outlet.
Be aware that some appliances can be delivered
with a polarized plug (one blade wider than the
other). To reduce the risk of electric shock, this
plug is intended to t in a polarized outlet only
one way. If the plug does not t fully in the out-
let, reverse the plug. If it still does not t, con-
tact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
3. POWER/LIGHT SWITCH
Your machine will not operate unless the power/
light switch is turned on. This same switch con-
trols both machine power and sewing light.
When leaving the machine unattended, or ser-
vicing the machine, remove the power line plug
from supply outlet.
4. OPENING FRONT COVER
To open front cover, pull it to the right and
down towards you.
5. OPENING WORKING TABLE
To open working table, pull the release lever to-
wards you with your right hand, and lift the front
of presser foot up with your left hand.
Note: The moving part at the front of the presser foot
is for protecting the ngers while sewing. Normally it is
down, but can be lifted momentarily to check cutting sta-
tus.
Connector
Socket
Power/light switch
Working table
Release lever
Front cover
Setting up your machine
To Next Page
Loading...
Need help?
General
