1:6
1:6
B
A
C
Operate your Pfaff select
Winding from the second spool holder
Push the second spool holder (7) into its
hole and place a spool of thread with the
corresponding spool cap on it.
Threading
Place the thread into guide A and pull
it through opening B to the right under
hook C. Wind the thread clockwise a few
times around the bobbin.
Switch on the main switch.
Hold the end of thread À rmly and press
the the foot control. The winding action
will stop automatically as soon as the
bobbin is full. Cut the thread, push the
bobbin to the left and remove it.
Don’t forget:
Turn the handwheel release disk (3)
back again. Then turn the handwheel (4)
towards you until it snaps into place.
TIP: If the machine is already threaded,
you can easily wind thread from the second
spool holder without having to unthread the
machine.
To Next Page
Loading...
Need help?
General
