Pfaff Creative 1473

Sewing texts
If you wish to divide a text into several lines, select
a free M-memory for each line and enter the
text.
After the last program entry, press
the single pat
tern key. Insert
a
spacing after
each
word
(page
145). Sewing is then
begun
with
the first M
memory
again. To
divide
the text, select one M
memory after the other with each part of the text.
The machine
will
stop after each line.
Before sewing, mark the beginning of the text on
the fabric.
After sewing, cut the joining threads
between let
ters, figures and spacings (Fig. 1).
If you wish
to
check the
text, press run-through
key, display 6. The text will
then
run
through in the
computer. It can
be stopped by pressing the same
key again.
Letters and figures
in different sizes
Letters and
figures can be sewn in different sizes.
The maximum character height is
9
mm.
Before
the
first entry of
a
letter or
a
figure,
its
height
can be
determined
by
means of
stitch
width key 8 (Fig. 2).
If
you wish to sew
letters and
numbers in different
heights,
select
the height
just
before the required
change
and
input the program in
the memory.
If
you
have missed
out a letter or figure or entered
a
wrong
one, you can correct the
entry. Cancel
the individual entries
back up to the mistake using
rn em — key 47 and correct it,
then enter the rest
of the text again.
Programming names with
embroidery
stitches
• Select
a
free M-memory
• Push
“mem+’
key
48
• Select the following
programs
1 x 132
2 x 00
EVA
2 x 00
1 x 132
• and enter them in
the computer by pressing
rnern+”
key
48 each time
• Press single
pattern key 27.
.- j
V7
-
-
Correcting program entries
146