Pfaff Creative 7510 A - Page 121

• Place
the
eyelet
plate
onto
the
needle
plate
making
sure
that
pin A
fits
into
the
middle
cutout
of the
needle
plate.
Then
push
the
eyelet
plate
down
at the
front
• Place
the
marked
fabric
taut
in
an
embroidery
hoop.
• Cut
one
or
two
fabric
threads
and
push the
fabric
over
the
pin
in
the
eyelet
plate.
The
fabric
must
fit
tightly
around
the pin.
• Place
the presser
foot
lifter
in
darning
position.
• Pull
up the
bobbin
thread
and
hold
it
tor the
first
few
stitches.
• Stitch
around
the
cut
with
your
chosen
program.
While
doing
so, turn
the
hoop
slowly
and.
The
stitches
must
be very
close
to
each
other.
• Then
secure
with
a few
straight
stitches.
And
here
is
how
it is
done:
•
Remove
the sewing
foot
TIP:
Select another
program
such
as 37
or 44.
In
this
way the
cut
in the
fabric
will
not
be stitched
around
or only
partly
stitched
around.
To
complete
this, select
program
27
and
stitch
around
the
cut
uniformly.
Thus
you
create
beautiful
petal forms.
117