Pfaff Creative 7510 A - Bobbin Winding Process; Winding from Main Spool Holder

I
s/fr
PC
An
k
I
Threading
Place
the thread into
guide C and
pull it under the
J
thread tension
disk B with both
hands. Wind
the
thread
clockwise a few
times around the
bobbin.
Push the bobbin to
the right
Switch on the
on/off switch
(25)
Hold
the end of the
thread firmly and
press the foot
control. The winding
action will stop
automatically
as
soon as the
bobbin is full. Cut the
thread, push
the bobbin to
the left and remove
it
Don’t
forget:
Turn the release
disk
(44)
fully back
again. Then
turn
the handwheel
(43)
towards you
until it snaps
into
place.
20
t
I
I
lU
IitIiIl
11
1..TEh
I
JIjLIHjiJJIJJIiiHJJ1
IN
L
I
AZ
L
I
Winding the
bobbin from the
spooi
holder
I
Place the sewing
thread on the
spool
holder
(39).
To
guarantee free
movement of
the thread and to
give
additional hold to the
thread spool,
fit an
unwinding
disk corresponding
to the size
of the
thread
spool.
L