Pfaff Creative 7510 A - Page 84

‘lace the gimp thread
over the front ridge. Pull the
hread ends taut
backwards under the sewing foot
Dlamp them
right and left of the back
ridge
respec
ively.
When
the
machine sews the first stitches of the
eyelet, pull down the
gimp thread from the back
ridge
using an ordinary pin.
mportant The sewing
foot may not be raised
luring this
procedure!
Pull
the gimp thread to the left
and backwards
until the loop is just in
front of the needle.
Now sew the eyelet
carefully.
. Sew
the first
buttonhole
bead.
• Then, hold the gimp thread slightly tauter and
finish sewing the buttonhole. Cut
off the loose
ends of the gimp thread. The round buttonhole
with gimp thread is sewn in the same way.
I
(eyhole buttonhole
with gimp thread
• Push the runner forwards up to the second
red
mark
• Before you start sewing, press the “needle
down” key
(4).
81