8
Start your Embroidery: Yarn or String of Beads
This section describes how to start embroider with yarn or string of beads. Note that the images only show
string of beads. The process is similar for yarn (see previous page). Find Yarn and String of Beads embroidery
tutorials in the “Embellishment Attachment” or “Embroidery Accessories” sections.
1. Move the yarn towards you, away from the needle.
2. Press start/stop to begin to embroider.
3. Hold still while the machine sews a few stitches to fasten the thread. The machine stops.
4. Move the yarn backwards so that it carfully pushes the thread back behind the needle. The yarn should be
behind the needle.
5. Press start/stop to begin to embroider.
6. The machine will sew a few stitches to fasten the yarn. Hold it in place with the threading wire.
7. After a few stitches, your machine will stop so that you can cut the yarn. Carefully cut the yarn underneath the
Embellishment Attachment.
Your machine will guide you through the embroidery! Pop-ups will appear on the screen telling you what to do!
To Next Page
Loading...
Need help?
General
