Pfaff creative sensation pro II - Page 48

3:10
PFAFF
®
creative
™
Color Touch Screen
6WLWFKZLGWKVDIHW\
Select this function when using a straight stitch
presser foot to lock the needle in center position for
all stitches, preventing damage to the needle and/or
presser foot.
This function is automatically selected, and cannot
be deselected, when the straight stitch needle plate
is attached.
When turning on the machine with this setting
activated and for every stitch selection that is not
a straight stitch, a pop-up informs you that it is set
to straight stitch. Deselect stitch width safety to go
back to normal sewing.
Note: Twin needle and stitch width safety cannot be used
at the same time.
6WDUWVWRSEXWWRQVDIHW\
Select this function to disable the start/stop button
in sewing mode. This prevents the machine from
starting to sew if the start/stop button is touched by
mistake. When this function is selected, you must
use the foot control to sew.
&XWMXPSVWLWFKHV
Your machine features the automatic function
Cut jump stitches. This function saves you time
trimming after the embroidery is completed. When
Cut jump stitches is selected your machine will trim
the top jump stitch thread and pull the thread end
to the underside of the fabric as you embroider.
Note: Your machine will also cut the thread after you
have changed to a new color. Hold the thread end when
you start embroidering again, so that you can easily
remove the thread end when cut.
Designs marked with this symbol are
programmed for Cut jump stitches. Trim
commands to cut jump stitches can be added
to any design using the software package
downloaded via the PFAFF
®
website (see page
2:13).
Automatic thread snips
When selected, the automatic thread snips is
activated. The threads are cut automatically and
the presser foot raises at color changes or when
DQHPEURLGHU\LVÀQLVKHG:KHQGHVHOHFWHGQR
automatic thread snips will be performed.
p