12
1
1
3
3
4
5
7
8
4
6
7
2
2
6
5
Threading the right needle (green)
1. Pass the thread from back to front through the thread guides
on the thread stand (1).
2. Pull the thread from left to right under the thread guide on
the back of the top cover (2).
3. Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between the
tension discs and pull it down to make certain it is properly
placed between the tension discs (3).
4. Continue to thread points (4-7).
Note: Be sure to pass the thread through the upper thread path
of the thread guide (6).
5. Thread the eye of the right needle (8). Use the tweezers to
make needle eye threading easier.
6. Pull about 10 cm of thread through needle eye to hang free.
7. Raise the presser foot and place the thread to the back,
under the presser foot.
Threading the left needle (blue)
1. Pass the thread from back to front through the thread guide
on the thread stand (1).
2. Pull the thread from left to right under the thread guide on
the back of the top cover (2).
3. Lift up the handle and bring the thread under it. While
holding the thread with both hands, pass it between the
tension discs and pull it down to make certain it is properly
placed between the tension discs (3).
4. Continue to thread points (4-6).
Note: Be sure to pass the thread through the lower thread path
of the thread guide (5).
5. Thread the eye of the left needle (7). Use the tweezers to
make needle eye threading easier.
6. Pull about 10 cm of thread through needle eye to hang free.
7. Raise the presser foot and place the thread to the back,
under the presser foot.
To Next Page
Loading...
Need help?
General
