11
(Fig.3-7)
(Fig.3-8)
Press ǏƷǐ and Ǐǐ to move the cursor to the required option, then pressǏENTERǐ to gain
access to the menu. Press ǏRETURNǐ to quit, returning to the preceding menu.
Setting Module Style
Press ǏƷǐ and Ǐǐ to move the cursor to the required option, then pressǏENTERǐ to select
among “8 cell”, “5 cell” and “fixed cell”. If the user choose “fixed cell”, the options irrelated to the fixed
cell are inoperative.
Cell Number
This option allows the user set the cells in use. Press ǏƷǐ and Ǐǐ to move the cursor to the
required option, then pressǏENTERǐ. The figure will increases one by pressing ǏENTERǐeach time.
The range is 1ü8.
Reagent Blank/Cell Blank/Blank Test
1) Reagent Blank
Press ǏƷǐ and Ǐǐ to move the cursor to the required option, then pressǏENTERǐto toggle
between “yes” and “no”. If you choose “yes”, the system will take the sample in the No.1 Cell as the
reagent blank to measure the samples in other cells (2-8).
2) Cell Blank
Press
ǏƷǐ
and
Ǐǐ
to move the cursor to the required option, then press
Ǐ
ENTER
ǐ
to toggle
between “yes” and “no”. The sample cells will differ from each other in optics characteristics subtly even
though they are made in the same way. When the user start cell blank, first put the blank in each sample
cell and save the measured value. Then put and measure the unknown sample in the cells. Using the
measured value deducts the saved blank sample value, and you can get the required measurement result.
3) Blank Test
Press ǏƷǐ and Ǐǐ to move the cursor to the required option, then pressǏENTERǐto test the
To Next Page
Loading...
Need help?
General