Phasak PH 9230 - Specifications Phasak; Technical Specifications

ON-LINE 1000VA / 2000VA / 3000VA
PH 9210 - PH 9220 - PH 9230 .
5. Specifications Phasak


Model
PH 9210
PH 9220
PH 9230
Configuration
Capacity (VA)
1000VA
2000VA
3000VA
Capacity (Watts)
900W
1800W
2700W
Form Factor
Tower
Energy-saving Technology
Yes, ECO Mode Efficiency ≧95%
Input
Input Voltage Range
80~300Vac± 5% for 1000/2000/3000VA model
@ 0~50% Load±5%
120~300Vac± 5%  for 1000/2000VA model
140~300Vac± 5%  for 3000VA only
@ 50~60%Load± 5%
140~300Vac± 5%  for 1000/2000VA model
160~300Vac± 5%  for 3000VA only
@ 60~80%Load± 5%
160~300Vac± 5%  for 1000/2000VA model
190~300Vac± 5%  for 3000VA only
@80~100%Load±5%
Input Frequency Range
40~70Hz
Input Power Factor
0.99
Cold Start
Yes
Output
Output Waveform
Pure Sine Wave
Output Voltage
208, 220, 230, 240Vac±1%
Output Frequency
50 / 60Hz (Auto-Sensing or Configurable) ±0. 5Hz*
Transfer Time (Typically)
0ms
Rated Power Factor
0.9
Harmonic Distortion
THD < 3% at Linear Load, < 5% at Non-linear Load @ Nominal Input
Crest Factor
3 : 1
ECO Mode Voltage
Regulation
±10%, ±15% (Configurable)
Protection
Surge Protection
IEC 61000-4-5 Level 4
Overload Protection
Line Mode： 105~110% Overload warning only (No shutdown)
110~120% Warning, transfer to bypass after 60s
>120%Transfer to bypass immediately
Battery Mode： 105~110% Overload warning only (No shutdown)
110~120% Warning, shutdown after 10s
>120%Shutdown immediately
Short Circuit Protection
UPS Output Cut off Immediately or Input Fuse / Circuit Breaker Protection
Battery
Specifications
(2) 12V/9AH
(4) 12V/9AH
(6) 12V/9AH
For long-run Models, NO Battery Inside.
Recharge Time (Typically)
4 Hours (inside batteries)
Sealed, Maintenance Free
Yes
Status Indicators
LCD Screen
Graphic LCD
Audible Alarms
Battery Mode, Battery Low, Overload, UPS Fault, Replace Battery, Bypass Mode
Charger Failure /Over Charged, Fan failure, EPO active
Environment
Operating Temperature
32℉ to 104℉ ( 0℃ to 40℃)
Operating Relative Humidity
20 to 90% Non-Condensing
Management
On-Device Features
Self Test, Auto-Charge, Auto-Restart, Auto-Overload Recovery
Connectivity Ports
(1) Serial Port (RS232), (1) USB Port,
SNMP/HTTP Capable
(1) Expansion Port (With optional card)
55 / 58