To Next PageTo Next Page
Need help?Do you have a question about the phase II+ MET-U1A and is the answer not in the manual?
General| Brand | phase II+ |
|---|---|
| Model | MET-U1A |
| Category | Test Equipment |
| Language | English |
Guides selection between dynamic and ultrasonic testing based on application.
Explains how to select the hardness scale using arrow buttons.
Details choosing between Test, Calibration, and Processing modes.
Covers battery installation, charging, and capacity indication.
Outlines inspection, surface prep, and transducer connection.
States calibration needs a special code and skilled personnel.
Details steps to enter calibration mode and display indication.
How to obtain mean hardness from the first reference block.
How to adjust the tester's display to match the reference block.
Repeats the measurement process for the second reference block.
Repeats correction and verifies calibration by re-measuring a block.
Steps for the first measurement using the U1 ultrasonic transducer.
Detailed instructions on applying pressure for ultrasonic measurement.
A critical warning against jamming the probe onto any surface.
How to connect and use the D1 dynamic transducer for measurement.
How to start a test by pressing the release button on the impact device.
Step-by-step guide for replacing the unit's batteries.
Troubleshoots display issues and unchanged readings.
A guide to quickly set up and start using the MET-U1A.
