Need help?Do you have a question about the phase II+ SRG-4000 and is the answer not in the manual?
Lists the SRG-4000 unit, probe, reference standard, screwdriver, and AC adapter.
Details the available measuring ranges for Ra, Rz, Rt and display resolutions.
Explains key surface finish parameters like Ra, Rz, Cutoff, Sampling Length, and Evaluation Length.
Provides detailed explanations and diagrams for Ra, Rz, Rq, and Rt measurement parameters.
Describes how to turn the unit on and select the cut-off length for measurements.
Details how to set the filter profile for typical applications, usually RC Filter.
Explains how to toggle between Inch/Metric units and select roughness scales (Ra, Rz, Rq, Rt).
Describes how to select the evaluation length from 1-5 for roughness measurements.
Emphasizes cleaning the surface from contaminants before testing.
Covers setting the unit flat, stylus orientation, and using auxiliary support.
Details how to start a measurement and save the results to memory.
Explains how to browse saved measurements, parameters, and delete groups.
Guides through entering calibration mode, taking measurements, and adjusting values.
Instructions for restoring default settings, often after probe replacement.
Explains the two ways to charge the unit's rechargeable battery.
Advice on protecting, storing, and cleaning the tester to ensure longevity.
Lists specific accessories like support stands and stylus extensions.
Provides step-by-step instructions for attaching the SRG-4000 unit to the test stand.
General| Power | 100-240 VAC, 50/60 Hz |
|---|---|
| Harmonics | <-30 dBc |
| Modulation | AM, FM, Pulse |
| Impedance | 50 Ω |
| Frequency Range | 10 MHz to 4 GHz |
To Next Page
