Machine Accessories Precision Tools Cutting Tools Material Testing Instruments
(201)962-7373
WWW.PHASE2PLUS.COM
Begin Measurements:
Once the unit is placed on the part to be tested you should press the START button.
You will see the display show 4 dashes as the stylus is making its pass. Once the
stylus returns to its starting position, the roughness value will be shown on the
display.
Saving your results:
After measuring, you will see the letter “M” will now have a dash over the top of the
letter. In this state, you can now save this group of results to memory by pressing the
button. Then the M with the dash over it will change to a regular “M”
without the dash over it automatically while the number of memorized groups
increases to “1”.
Browsing Parameters:
While in the “M” with the dash over it state, you can toggle between different
roughness scales (Ra, Rz, etc.)
Deleting Measurements:
While in the “M” with the dash over it state, you can delete this group of results by
depressing the button. Then the M with the dash over it will now become
just the regular “M”. New measurements will replace the old measurements if you
press the Start button while in the M dash state.
Browsing Memorized Data:
Regardless of the “M” state, you can see your results by pressing the button.
This browsing state is marked on the display with the letter “R”
When in the “R” state, you can browse different groups by pressing the
or buttons. The serial number of the group will show on the display.
For each group, you can still browse through the roughness scales. When picking a
roughness scale, the unit will give you the results in the corresponding scale.
To Next Page
Loading...