24
ROUTINE MAINTENANCE
WARNING
Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in
order to prevent electric shock or injury.
Ensure you do not inhale or consume medication or aerosols from around the unit at the time of
maintenance. These may be harmful to your health.
CAUTION
Always put on the dry gloves to protect the hands at the time of maintenance. No gloves may cause
cut of the finger by the edge or corner.
Cleaning of cabinet
■ Clean the unit once a month. Regular cleaning keeps the unit looking new.
■ Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all
accessories. If the outside panels are dirty, clean them with a diluted neutral dishwashing detergent.
(Undiluted detergent can damage the plastic components. For the dilution, refer to the instruction of the
detergent.) After the cleaning with the diluted detergent, always wipe it off with a wet cloth. Then wipe
off the cabinet or accessories with a dry cloth.
■ Never pour water onto or into the unit. Doing so can damage the electric insulation and cause failure.
■ The compressor and other mechanical parts are completely sealed. This unit requires absolutely no
lubrication.
Note: Always replace the inner accessories removed for the cleaning to keep the intended performance.
Cleaning of evaporating tray
CAUTION
Dispose of the water in the evaporating tray completely. Spilled water or splashed water may cause
current leakage or electric shock.
Clean the evaporating tray regularly. The dusty tray may cause poor evaporation.
1. Remove 2 black screws at the lower front of the unit.
2. Pull the evaporating tray directly out; it is touching the
floor. Pull it out by sliding it along the floor.
3. After cleaning, slide the evaporating tray along the
floor.
By lifting up the back it can be pushed further inward.
4. Fix the evaporating tray with 2 black screws.
To Next Page
Loading...