Philips 10BDL4151T - Operation and Setup; Initial Setup Wizard

8
4.2. Disclaimer
Image Retention Disclaimer
When an image is monitored on-screen for prolonged
periods of time, you may see a faint image after it is
replaced. This is expected normal behavior for
monitors.
Image retention may be reduced by:
* Avoiding still images shown on-screen for more than
a few minutes
* Using non-contrasting colors and brightness
* Using background colors other than gray
5. Operation
5.1 Setup wizard
5.1.1 Setup wizard flow:
Android Setup Wizard
PS:
(1)The default of Navigation bar is “enable”. You can
see it through all setup wizard flow.
(2)Only the 1st time you enter Android mode will go to
setup wizard.
(3)Do Factory reset in Android mode, it will run setup
wizard again.
Switch forward/backward among pages
(1) Welcome
Start: Network Settings
(2) Security Setting
Back Page: Welcome
Next Page: Signage Display Settings
Skip Page: Signage Display Settings
(3) Signage Display Settings
Back Page: Security Setting
Next Page: Import from SD / Import from USB / Manual
Setup
Skip Page: Network Settings
(4) Network Settings
(3-1) Manual Setup
Back Page: Signage Display Settings
(4) Network Settings
Back Page: Signage Display Settings
Next Page: Wireless / Ethernet
Skip Page: Clone Media Files into internal
(4-1) Sub Page
Wi-Fi
Back Page: Network Settings
Next Page: Clone Media Files into internal
Ethernet
Back Page: Network Settings
Next Page: Clone Media Files into internal
Welcome
(Select Language)
Security Setting
(Select Security Item)
Clone Media Files into internal
(Select Clone Type)
Network Settings
(Select Wireless or Ethernet)
Signage Display
Settings
Security Setting
(Select Security Item)
Network Settings
(Select Wireless or Ethernet)
Signage Display Settings
(Select Import Type)