Philips 160E1SB/93 - If Paint Is Used; Plastic Mold Tooling; Plastics Flammability; Texture;Glossing of Housing

79
Meridian 1
If paint is used
x
RoHS required
x
WEEE require
x
If new painting type needs to implement, refer to UN-D 1235.
Plastic mold tooling
x
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to “TYV61-90007”.
x
Painting to cover up cosmetic defects due to molding is strongly discouraged.
x
China RoHS mark requested.
Plastics flammability
x
All Plastics to be Flame Retardant UL 94-HB.
x
Base / Rear to be Flame Retardant UL 94-HB
x
All major plastic parts (bezel, back cover) need to be molded from same resin
x
Plastic resin type selection should be referred to “plastic-Philips Pool monitor”
Texture/Glossing of housing
x
The texture area and texture no should follow Philips make-up sheet.
x
The exterior surfaces shall have a uniform texture.
x
Philips must approve the mold texturing.
x
Detail document for texture refer to “UN-D249”, “UN-D 600”.
x
> = 80 gloss units
Tilt and swivel base
x
Tilt angle : -5 q +2/- 0 q (forward)
+20 q+0/- 2 q (backward)
x Tilt for left and right:
ΊA-BΊ3.0MM
x Black side and cut side˖
1. Visual area
H˖L-R0.8~1.0mm
V˖U-D0.8~1.0mm
2. Black side on the left and right is
symmetrical, not cut side.
x Gap between bezel and rear cover 0.2 mm (Typ.) Max. will wait for 1
st
lot of MP to correct the data.
x Step between bezel and rear cover Left, right and top: 0.3mm Bottom and corner: 0.5mm
x "Wobble", "Twist", etc (front to back or side to side)
Whole monitor set shall retain stability within a short time after the applied external force disappears.
20NT , 6secs˄Max.˅ back to stable.
R
L
U
D
A
B