Philips 170S8FS/00 - Electrical Characteristics; Interface Signals; Scanning Frequencies; VIDEO: 0.7 Vp-P, INPUT IMPEDANCE, 75 OHM @DC

102
HUDSON 8
AUO M170EG01 VD
Resolution : 1280x1024 (SXGA)
Outside dimensions :
Pitch ( mm ) : 0.264 mm x 0.264 mm
Color pixel arrangement : RGB vertical stripes
Display surface : Anti-glare type, Hardness 3H
Color depth : 16.7 M color (RGB 6 bits + FRC data)
Backlight : CCFL
Active area(WxH) : 337.9*270.3
View angle (CR>10) : 160/160 (typ)
Contrast ratio : 800:1 (typ)
White luminance : 300 nits (typ)
Color gamut : 72% (typ)
Gate IC :
Source IC :
Response time : 5ms
2.2 Scanning frequencies
Hor. : 30 – 83 K Hz
Ver.: 56 - 76 Hz
Video dot rate: <140 MHz
Power input: 90-264 V AC, 50/60 ± 2 Hz
Power consumption : : 36 W typical
Functions:
(1)D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature: 0 °C - 40 °C
3. Electrical characteristics
3.1 Interface signals
1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level , input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3). Audio: NOTE
4). USB PLUG 2.0: NOTE
http://www.wjel.net