35
English
EN
PBS settings
[PBS mode]
Enables / disables the Professional mode.
[On]: All settings in the Professional
mode Setup menu are in effect.
[Off]: The TV operates as a normal
(consumer) TV.
[Consumer setup]
A shortcut to enter the full TV menu. This
allows the installers to do all the TV setup
settings.
[USB to TV]
video, audio, channel Table, and Professional
mode settings) from a USB device to the TV set.
[TV to USB]
video, audio, channel Table, and Professional
mode settings) from the TV set to a USB
device.
[Reset]
Selects [Yes] to reset all settings in Professional
mode to factory default.
Switch on setting
[Max volume]
volume level of the TV.
[Switch on picture format]
Sets available picture format when the TV is
switched on.
Note
If the picture format is not supported
with the activated source, [Auto format]
detection is applied.
[Power on]
The power on function allows the TV to enter
[On], [Standby], or [Last
status]) of operation after the mains power is
activated.
[On]: When set, the TV will always
turn on after the mains power is
activated.
[Standby]: When set, the TV will
always turn to standby after the mains
power is activated.
[Last status]: When set, the TV will
always turn to the last status (either
On or Standby) whenever the mains
power is activated.
[Smart power]
Adjusts the picture backlight to achieve the
following power saving mode.
[Off]: Smart power is disabled.
([Custom] mode is applied).
[Low]: The picture backlight is at low
power saving mode. ([Cinema] mode
is applied).
[Medium]: The picture backlight
is at medium power saving mode.
([Standard] mode is applied).
[High]: The picture backlight is at high
power savings mode. ([Energy saving]
is applied).
To Next Page