ʳ
ʳ
ʳʳʳʳʳ
ʳ
ʳ
ʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳʳ˃ˁ˄ 222E2 21.5” Wide FHD LCD Monitor
2010/02/05 PHILIPS 15 of 30
222E2 LCD 67
General Product Specification
Linkage between SmartImage Lite OSD and main OSD
A. Settings within main OSD have linkage with Smart Image OSD.
i. Brightness
ii. Contrast
iii. Color Temperature
B. Because each preset profiles will define default setting of these 3 parameters. Users
can understand what is the value of that in preset profile by open the main OSD.
C. When any SmartImage Lite profile had been enabled. The parameters in main OSD are
still available for user to adjust. But these adjustments are temporary only. If users switch
to another profile and then go back. The setting in main OSD will show preset values of
that SmartImage profile enabled.
Profile Definitions (system integrators to input at design stages)
A. Standard
i. Purpose: Default out of box settings, No optimization by SmartImage.
ii. Design:
1. This will follow user OSD setting. If any change by user, it will be
saved. When switch back from other SmartImage profiles, it will
go back to last saved setting.
2. Default out of box settings
3. Same as OFF mode settings in SmartImage
B. Internet
i. Purpose: Design for Internet application, especially web browsing.
The screen is mixed by text & picture. Desktop publish could use this
profile also.
ii. Enhancement Point:
1. The enhancement will be mostly based on the "Image viewing"
settings that are also under definition, made milder by the higher
probability of strong compression typical of the Internet photos
and clips.
To Next Page
Loading...
