Specifications
z
Tuningfrequency: 61.25 MHz (channel 3)
z
Color system: NTSC M
z
All picture settings at 50% (brightness,color contrast, hue)
z
Bass, treble and balance at 50%; volumeat 25%.
z
All service-unfriendly modes (if present) aredisabled. The service unfriendly modes are:
(sleep) timer
child/parental lock
blue mute
hotel/hospitality mode
auto shutoff (when no "IDENT" videosignal is received for 15 minutes)
skipping of non-favorite presets / channels
auto-storage of personal presets
auto user menu timeout
z
Run timer (maximum four digits displayed)
z
Software version
z
Option settings
z
Error buffer reading and erasing
z
Software alignments
How to enter SDAM
To enter SDAM, use one of the following methods:
z
Press thefollowing key sequence on the remote control transmitter:
z
0-6-2-5-9-6-MENU
z
Do not allow the display to time out betweenentries while keying the sequence.
z
Short jumper wires 9631 and 9641 on the monocarrier (see Fig. 8-1) and apply AC
power. Then press the power button(remove the short after start-up). Caution :Entering
SDAM by shorting wires 9631 and 9641 will override the +8V-protection.Do this only for a
short period. When doing this, the service-technicianmust know exactly what he is doing,
as it could damage the televisionset.
z
Or via ComPair (with the ComPair "Tools" RC7150Service Remote, it should be possible
to enter SDAM via the ComPairinterface IR).
After entering SDAM, the following screen is visible,with S at the upper right side for
recognition.
Pa
e 4 of 16SPMS
7/8/2004
To Next Page
Loading...
