21NEXTVIEW
Acquisition and updating of NEXTVIEW information
Acquisition and updating of NEXTVIEW is done when you are watching the TV
channel of the selected
NEXTVIEW provider, see Setup menu p. 8, or when the
TV is switched to standby.
The indicator on the front of the TV remains orange during standby.
After all needed acquisition or updating is complete, it turns red.
Acquisition of fresh data will happen once during the night.
Note: it may be necessary to put the TV in standby mode when all
NEXTVIEW
information is outdated, e.g. returning from holiday.
Video recorder restrictions with NEXTVIEW
The Record item and the automatic recording will only be present and
possible if your video recorder is equipped with
NEXTVIEW
Link.
Your video recorder should be connected to
EXTERNAL 2. See Connect
Peripheral Equipment, p. 25.
The daily, weekly and series options, the number of recordings set and the
way overlapping recordings are managed, depend on the type of video
recorder you have.When all video recorder timers are full, the item
Record
in the menu will not be present.
Upload video recorder overview
When the TV is switched on, the timer recording are uploaded to the TV to
check if any manual addition or deletions have been done.This is shown in the
overview.
The video recorder manages and removes timer recordings when performed.
Some
NEXTVIEWLink video recorders do not allow a daily programming of the
recording to start on a Saturday or Sunday. In this case the item
daily will be
removed from the menu on those days.
To Next Page
Loading...
