Alignments
EN 27L11M1.1L LA 6.
2011-Jun-24
back to
div. table
How to Change Options Codes
An option code (or “option byte”) represents eight different
options (bits). All options are controlled via ten option bytes
(OP#1... OP#10).
Activate SAM and select “Options”. Now you can select the
option byte (OP#1... OP#10) with the CURSOR UP/ DOWN
keys, and enter the new 3 digit (decimal) value. For the correct
factory default settings, see the sticker inside the set.
To Next Page
Loading...
