Philips 32PFL4664/F7 - Page 24

4-12 PL19.00-B_DC
(2) Parts to be removed or installed.
(3) Fig. No. showing procedure of part location
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
H = Hex Screw, CN = Connector
e.g. 2(S-2) = two Screws of (S-2),
2(L-2) = two Locking Tabs of (L-2)
(5) Refer to the following “Reference Notes in the
Table.”
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the LCD
Panel Assembly.
• Do not pull the FFC Cable and Board Cable
forcefully when you re-assemble.
• Be careful not to scratch the display panel when
assembling.
2. When you disassemble/re-assemble the IR
Sensor CBA Unit.
• Be careful not to scratch the display panel when
assembling.
• Make sure the Sensor Shield, Sensor Lens and IR
Sensor CBA Unit are securely in place when re-
assembling.
3. When you disassemble/re-assemble the Front
Cabinet.
• Be careful not to break the hook. If you pull with too
much force, the hooks may be damaged.
• Make sure to replace the Cell Cushion, Gasket, and
Grand Tape to a new one when replacing the Front
Cabinet.