3.6 Switch on and setup theTV
The -iV switches on automatically after connectingthe power cord.
PHILiPS
@ Next
Press the GREEN Next button located on your remote control to proceed.
Follow the on-screen instructions to select your language and complete
your TV setup. Installation takes approximately 10 minutes.
Note: If you connect yourTV to a cable box or satellite set-top
box, you do not need to install channels. Press the red button on
the remote control to exit the channel installation stage of the setup.
Finish the setup by selecting your location:
• If you choose Retail store your settings will be are erased each
time you turn off the TV. This mode is only to be used for retail
store displays.
• If you choose Home you are guided through a choice of picture
display options. Use the left and right cursor to select your
preferred screen.
EN-9
To Next Page
Loading...
