• YPbPr (ComponentVideo Input)
• HDMI
For information about how to connect a set-top box, see the Quick Start
Guide provided.
Connect a set=top box through RF IN/OUT
if the TV is connected to a cable box or satellite set-top box via a
coaxial connection, set the TV to channel 3 and 4, or the channel
specified by the service provider.
_
Connect a set-top box through component video input or
HDM|
• ,D_,
3.4 Connect the power cord
WARNING: Verify that your voltage corresponds with the
voltage printed at the back of theTV. Do not insert the power
cord if the voltage is different.
To connect the power cord
1. Locate the power connector at the back of the TV.
The location of the power connector varies according to TV model.
w!
2. Insert the power cord fully into the TV power connector.
3. Connect the power cord plug to the power outlet. Ensuring that the
cord is tightly secured at both ends.
To disconnect the TV from the power outlet
The TV set is always connected to the power.You can disconnect the TV
from the power by doing one of the following tasks:
• Unplug the power cord located at the back of the TV.
• Unplug the power cord from the power socket outlet.
Pull the power cord by the plug - do not pull on the power cord.
3.5 Manage cables
Route your power cord, antenna cable and all other device cables
through the cable holder at the back of the TV. This holder helps keep
'our cables tidy and easily manageable.
EN-8
To Next Page
Loading...
