To Next PageTo Next Page
Why is there no picture on my Philips Monitor?
There are several reasons why your Philips Monitor might not be displaying a picture: 1. The power cord might be disconnected; plug it in. 2. The main power switch on the back of the display might not be switched on; ensure it is on. 3. The selected input might have no connection; connect a signal to the display. 4. The display might be in standby mode.
What to do if I failed to set up my Philips Door locks?
If you failed to set up the lock of your Philips Door locks, ensure the lock is installed correctly, insert fresh batteries, and make sure the cable is not pinched. After installation, reset the lock to factory settings to complete the lock setting process.
What to do if Latch Bolt makes sounds but does not work on Philips Door locks?
If, after installation, the Latch Bolt on your Philips Door locks makes sounds but does not work, ensure you have followed the installation instructions, re-install and reset the lock, making sure the Latch Bolt is fully retracted before installing the Exterior and Interior Assembly, not inserting the key during installation, correctly inserting the cable connector of the Exterior Assembly to the socket on the Interior Assembly, keeping the Exterior and Interior Assembly aligned and parallel to the door edge, and the Latch Bolt parallel to the door edge. Restore the lock to the factory default setting and use new 4 AA dry batteries.
Why am I receiving low battery alerts on my Philips Door locks?
If you are receiving low battery alerts on your Philips Door locks, remove the current batteries and insert 4 new AA alkaline batteries.
Why is auto-lock not working on my Philips Door locks?
If the Auto-Lock feature isn't working on your Philips Door locks, and the battery indicator is flashing continuously, replace the batteries with 4 new AA alkaline batteries. Also, ensure that you have activated the Auto-Lock function.
How to reset Master PIN Code on Philips Door locks?
If you forgot your Master PIN Code for your Philips Door locks, perform a factory reset. This will clear all PIN codes, and the Master PIN Code will revert to the default: 12345678.
Why can't my device connect to my Philips Speaker System soundbar?
If a device cannot connect with your Philips soundbar, it might be due to several reasons. The device may not support the compatible profiles required for the soundbar. Ensure you have enabled the Bluetooth function of the device (refer to the device's user manual). Also, check if the device is correctly connected. If the soundbar is already connected to another Bluetooth device, disconnect that device and try again.
How to fix a Philips Coffee Maker that does not turn on?
If your Philips Coffee Maker doesn't turn on, ensure it's properly connected to the electric network and that the power button is switched to the “I” position.
What to do if Philips Door locks only locks but does not unlock?
If your Philips Door locks only locks but does not unlock, or the Latch Bolt goes in and out uncontrollably, it might be due to a problem with the door frame. Ensure the hole in the door frame is drilled a minimum of 1"(25mm) deep to provide enough space for the deadbolt. It can also be because of the lock handing or installation. Restore the lock to the factory default setting. If that doesn't work, re-install the lock and reset it again. If the issue persists, further assistance may be needed.
What to do if Philips Monitor image doesn’t fill up the full size of the screen?
General| Display Type | LED |
|---|---|
| Refresh Rate | 60 Hz |
| Dimensions (Without Stand) | Varies by screen size |
| Weight (Without Stand) | Varies by screen size |
| Screen Sizes | 43" |
| Connectivity | Wi-Fi |
