Philips 5000 LATTE GO - Page 37

PHI 5000 LATTE GO / GO+ 04 DIAGNOSTIC MODE
9/8
When the Steam-Out is complete the following parameters are reset to their default values
Parameters Default value Description
Espresso_pulses_qty 150 Length “Espresso” product
Coffee_pulses_qty 360 Length “Coffee” product
Cappuccino_pulses_qty 150 Length “Cappuccino” product – Number of ow meter
impulses during coffee cycle
Cappuccino_milk_brew_time 230 Length “Cappuccino” product – Time of milk
brewing (x100ms)
Lattemacchiato_pulses_qty 150 Length “Latte Macchiato” product – Number of ow
meter impulses during coffee cycle
Lattemacchiato_milk_brew_
time
360 Length “Latte Macchiato” product – Time of milk
brewing (x100ms)
Americano_coffee_pulses_qty 150 Length “Americano” product – Number of ow
meter impulses during coffee cycle
Americano_water_ puls-
es_qty
310 Length “Americano” product – Number of ow
meter impulses during hot water cycle
CafeAuLait_pulses_qty 280 Length “Cafè au lait” product – Number of ow
meter impulses during coffee cycle
CafeAuLait _milk_brew_
time
160
Length “Cafè au lait” product – Time of milk
brewing (x100ms)
FrothMilk_milk_brew_time 320 Length “Froth Milk” product – Time of milk
brewing (x100ms)
Coffee_Grinder 0 Number of grounds in dregs drawer
Alarm_Rell TRUE Request priming circuit next power-on of the machine
Bu_Loaded FALSE Set Brew-unit clean and not ll with coffee
Aroma_Espresso 3 Beans Aroma for high pressure products
Aroma_Drip 4 Beans Aroma for low pressure products (not used in Incan-
to machine)
LastErrorLogged 0 Last error saved in machine
Gr_bu_uc_arr[jj] 150 Array of last 4 brew unit effort during rinsing cycle (in
milliamperes). Autozero for new autodose system
Gr_time_aroma[Light] 3000 Grinding time for aroma 1 (ms)
Gr_time_aroma[Medium] 3500 Grinding time for aroma 2 e aroma 3 (ms)
Gr_time_aroma[Strong] 4000 Grinding time for aroma 4 e aroma 5 (ms)
Coffe_Duct_empty TRUE Set grinder conduct clean – used to increase
grinding time for rst grinding product next
power-on.
DebugGrinder FALSE If true machine enter in debug mode next
power-on.
Filter_autonomy 0 Autonomy of last Aqua clean lter actived
Filter_counter 0 Number of Aqua clean lter actived in aquaclean
chain
Filter_startup_qty 5000 Counter of water for enable rst Aqua Clean
lter; if expire, the machine need a descaling
action to activate a new lter.
InstallFilterRemind TRUE Request Aqua clean lter activation next poweron
TimeSleep 15 minutes Timer for enter in stand-by from normal mode
Filter_Present FALSE Presence of Aqua Clean lter in machine