Philips 5000 LATTE GO - Table of Contents

PHI 5000 LATTE GO / GO+
3. Operating logic
3.1. Single microswitch gear motor 1
3.2. Temperature sensor (adjustment) 1
3.3. Coee grinder 2
3.4. Autodose system description 2
3.5. Coee lack detection and coee grinder blocked 3
3.6. Coee cycle 3
3.7. Milk container 4
3.8. Water level detection (water tank) 4
3.9. AquaClean water lter 5
3.10. Descaling request 5
4. Diagnostic Mode
4.1. Test Mode 1
4.2. Grinder Tuning 7
4.3. Steam out 8
4.4. Error codes 10
5. Saeco Service Center
5.1. Saeco Service Center - Quick Start Guide 1
6. Machine Repair Flow
6.1. Repair Flow 1
Table of contents Page
1. Introduction
1.1 Consumer Replaceable Parts (CRP) List 1
1.2. Specic tools and equipment 3
1.3. Maintenance product 3
1.4. Safety warnings 3
1.5. Water circuit diagram 4
1.6. Electrical diagram 5
1.7. Service POLICY grid as used for coee machine 6
1.8. External machine parts 6
1.9. Customer menu in the PHI 5000 Latte Go / Go+ 8
1.10. Operation, cleaning and maintenance 10
1.11. Brew Unit mainteinance: Where to grease 11
1.12. Position of the Brew Unit 11
1.13. Internal machine parts 12
2. Technical specications
2.1. Specication for the measurement of the coee products
temperature.
1
2.2. Specication for the measurement of the Milk products
temperature.
2
2.3. Machine parameters and performance 4
Table of contents Page
7. Disassembly
7.1. Outer Shell 1
7.2. Dispenser 2
7.3. Coee grinder 3
7.4. Grinder blades 3
7.5. Coee grinder adjustment 5
7.6.
Carafe connection and hot/steam water dispenser
6
7.7. Central plate 6
7.8. Pin boiler 7
7.9. Gear motor 7
7.10. Pump 8
7.11. Flow-meter 8
7.12. Boiler 8
7.13. CPU board 9
7.14. Programming access for EPSC (Espresso Philips Service
Center)
9
7.15. KYB interface and display 9
7.16. Two way solenoid valve 10
7.17. Fitting and removing Oetiker clamps 10