8 EN
Switch channels
• Press CH+/- on the remote control .
• Enter a channel number using the numeric
buttons on the remote control.
• Press on the remote control to switch
and return to the previous channel.
View installed channel
All available channels can be viewed in the
channel list.
LIST
1 Press LIST.
» The channel list appears.
2 Press to select channels and to
browse the channel list.
3 Press OK to watch the selected channel.
4 Press to switch and return to the last
watched channel.
Watch connected devices
Note
• Switch on the device before selecting it as an external
signal source.
4 Using the TV
This section helps you to perform basic TV
operations.
Switching the TV on or off
Standby indicator
To switch on
• Plug in the power plug.
» If the standby indicator is red, press
(Standby-On) on the remote control.
To switch to standby
• Press (Standby-On) on the remote
control.
» The standby indicator switches to red.
Tip
• Though your TV consumes very little power when
in standby mode, energy continues to be consumed.
When not in use for an extended period of time,
disconnect the TV power cable from the power outlet.
To Next Page
Loading...
