Mechanical Instructions
EN 12 TPS15.3A LA4.
2015-Oct-23
back to
div.table
4.3.5 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
4.3.6 Speakers
1. Gently release the tapes that secure the speaker cables.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.3.7 IR/LED board
1. Unplug the connector from the IR/LED board.
2. Gently release the clip that holds the board and take it out
from the DECO_BEZEL.
When defective, replace the whole unit.
4.3.8 LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the keyboard control panel as described earlier.
4. Remove the stand as described earlier.
5. Remove the IR/LED as described earlier.
6. Remove the WIFI module as described earlier.
7. Remove the fixations screws that fix the metal clamps to
the front bezel. Take out those clamps.
8. Remove all other metal parts not belonging to the panel.
9. Lift the LCD Panel from the bezel.
When defective, replace the whole unit.
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See Figure 4-1
to
Figure 4-2
.
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
To Next Page
Loading...
Need help?
General