2.5
Antenna Cable
Insert the antenna plug firmly into the
Antenna
socket at the
back of the TV.
You can connect your own antenna or an antenna signal from
an antenna distribution system. Use an IEC Coax 75 Ohm RF
antenna connector.
Use this antenna connection for DVB-T and DVB-C input
signals.
2.6
Satellite Dish
One Tuner
To watch a satellite channel and to record another channel at
the same time, you must connect 2 identical cables from your
satellite dish to the TV. If you only have 1 cable available, the
channel you are recording is the only channel you can watch.
Connect the cable from the satellite dish directly to the
SAT 1
connection. Use a coaxial cable fit for connecting a satellite
antenna dish. Make sure your satellite dish is perfectly aligned
before you start the installation.
During the satellite installation, select
One Tuner
.
Two Tuners
To watch a satellite channel and to record another channel at
the same time, you must connect 2 identical cables from your
satellite dish to the TV.
Connect the first cable from the satellite dish directly to the
SAT
1
connection and connect the second cable to
SAT 2
. Use a
coaxial cable fit for connecting a satellite antenna dish. Make sure
your satellite dish is perfectly aligned before you start the
installation.
During the satellite installation, select
Two Tuners
.
Unicable or MDU
If you use a Unicable system, connect the cable to the
SAT
1
connection. Use a coaxial cable fit for connecting a satellite
antenna dish. Make sure your satellite dish is perfectly aligned
before you start the installation.
During the satellite installation, select
Two Tuners
and
later
Unicable
.
7
To Next Page
Loading...
Need help?
General
Weight and Dimensions
