Philips AC1213/40 - Using the Air Purifier; Understanding the Air Quality Light; Turning on and off

2 Touch to switch on the air purier
(Fig. j).
» The air purier beeps.
» The air purier operates under
the auto-purication mode by
default.
» When the air purier is warming
up, " " displays on the screen.
» After measuring the air
quality for approximately
30 seconds, the air quality
sensor automatically selects the
appropriate air quality light color.
» After measuring the particle
matters in the air, the air
purier shows the PM2.5
level and operates in the
auto -purication mode.
3 Touch and hold for 3 seconds to
switch o the air purier.
Note
• If the air purier stays connected
to the electrical outlet after turning
OFF, the air purier will operate
under the previous settings when
turned ON again.
• If the air purier accidentally
shuts o during running, it restarts
automatically and operates under
previous settings when the power
supply is resumed.
• The air purier operates in PM2.5
display mode by default.
• If the PM2.5 level is higher than 99,
"--" will be displayed on the screen.
4 Using the air
purifier
Understanding the air
quality light
Air quality light color Air quality level
Blue
Good
Blue-Purple
Fair
Purple-Red
Poor
Red
Very poor
The air quality light automatically goes
on when the air purier is switched on,
and lights up all colors in sequence.
After approximately 30 seconds, the
air quality sensors select the color that
corresponds to the surrounding air
quality of airborne particles.
Turning on and o
Note
• Always place the air purier on a
stable, horizontal, and level surface
with the front of the unit facing
away from walls or furniture.
• For optimum purication
performance, close doors and
windows.
• Keep curtains away from the air inlet
or air outlet.
1 Put the plug of the air purier in the
power socket.
6 EN