Philips AC2729/10 - Replacing the Humidification Wick

16 EN
1 Take the wick wheel o the wick
support (g. †).
2 Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (g. ).
3 Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel (g. ).
4 Take the used NanoCloud rotary
humidication wick out (g. ).
5 Remove all packaging material
of the new NanoCloud rotary
humidication wick (g. l).
6 Place the new NanoCloud rotary
humidication wick in the wick
wheel, and then fasten the locks on
the wick wheel (g. ‘).
7 Place the wick wheel on the wick
support (g. m).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8 Place the water tray and water tank
back into the appliance (g. n).
9 Touch and hold for 3 seconds
to reset the NanoCloud rotary
humidication wick lifetime counter.
Filter alert light
status
Follow this
A3 is displayed
and the lter
replacement light
ashes on the
screen.
Replace the
NanoProtect
lter Series 3
(FY1410)
C7 is displayed
and the lter
replacement light
ashes on the
screen.
Replace the
NanoProtect
lter Active
Carbon (FY1413)
1 Remove the used lters from the
appliance (g. Œ).
Note
• Do not touch the pleated lter
surface, or smell the lters as they
have collected pollutants from the
air.
• Wash your hands after disposing of
the used lters.
2 Remove all packaging material of
the new lters (g. f).
3 Place the new lters into the
appliance (g. g).
4 Touch and hold for 3 seconds to
reset the NanoProtect lter lifetime
counter.
Replacing the
NanoCloud rotary
humidication wick
Filter alert light status Follow this
F1 is displayed and
the lter replacement
light ashes on
the screen (g. ).
Replace the
NanoCloud
rotary
humidication
wick