Philips AC2889/10R1 - Cleaning; Cleaning the Body of the Air Purifier; Cleaning the Air Quality Sensor; Cleaning the Pre-Filter

10 EN
Note
• If the air purier is used in a dusty
environment, it may need to be
cleaned more often.
• If the humidity level in the room
is very high, condensation may
develop on the air quality sensor
and the air quality light may indicate
a more poor air quality even though
the air quality is actually good. If this
occurs, clean the air quality sensor
or use the air purier on a manual
speed setting.
1 Switch o the air purier and
unplug from the wall outlet.
2 Clean the air quality sensor inlet
and outlet with a soft brush (g. u).
3 Open the air quality sensor cover
(g. v).
4 Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab (g. w).
5 Dry all parts thoroughly with a dry
cotton swab.
6 Reattach the air quality sensor
cover (g. x).
Cleaning the pre-lter
Clean the pre-lter when F0 is displayed
on the screen(g. y).
1 Switch o the air purier and unplug
from the wall outlet.
2 Pull the bottom part of the front
panel to remove it from the air
purier (g. c).
3 Press the two clips down (1) and pull
the pre-lter towards you (2)(g. d).
4 If the pre-lter is very dirty, use a
soft brush to brush away the dust
(g. z). Then wash the pre-lter
under running tap water.
5 Cleaning
Note
• Always turn the air purier o and
unplug from the electrical outlet
before cleaning.
• Never immerse the air purier in
water or any other liquid.
• Never use abrasive, aggressive, or
ammable cleaning agents such as
bleach or alcohol to clean any part
of the air purier.
• Only the pre-lter is washable. The
air purication lter is not washable
nor vacuum cleanable.
• Do not attempt to clean the lters
or air quality sensor with a vacuum.
Cleaning the body of the
air purier
Regularly clean the inside and outside
of the air purier to prevent dust from
collecting.
1 Use a soft, dry cloth to clean both
the interior and exterior of the air
purier.
2 The air outlet can also be cleaned
with a dry, soft cloth.
Cleaning the air quality
sensor
Clean the air quality sensor every
2 months for optimal functioning of the
purier.