Philips AC3829 - Cleaning the Pre-Filter; Descaling the Nanocloud Rotary Humidification Wick

14 EN
Note
• Make sure that the pre-lter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-lter.
5 After the pre-lter is completely dry,
place it back into the back panel
(g h).
6 Touch and hold for 3 seconds to
reset the pre-lter cleaning time.
Descaling the
NanoCloud rotary
humidication wick
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-lter cleaning
alert goes on
Descale the
NanoCloud
rotary
humidication
wick
1 Pull out the water tank (g j).
2 Lift the water tray upwards and pull
it out horizontally (g k).
3 Take the wick wheel o the wick
support (g †).
4 Soak the NanoCloud rotary
humidication wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(g ˆ).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7 Place the water tray back into the
appliance (g n).
8 Place the water tank back into the
appliance (g r).
Cleaning the pre-lter
Note
• If the pre-lter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-lter cleaning
alert goes on
Clean the pre-
lter
1 Pull the top part of the back panel
towards you to release it from the
appliance (g c).
2 To remove the pre-lter, press the
two clips down and pull the lter
towards you (g d).
3 Wash the pre-lter under a running
tap. If the pre-lter is very dirty, use
a soft brush to brush away the dust
(g ‡).
4 Air dry the pre-lter.