Philips AC3829 - 3 Get started; Installing the NanoProtect filter; Preparing for humidification

7EN
English
Preparing for
humidication
1 Pull out the water tank (g j).
2 Lift the water tray upwards and pull
it out horizontally (g k).
3 Remove all packaging material
of the NanoCloud rotary
humidication wick (g l).
Note
• The humidication wick has been
assembled on the wick wheel upon
purchase.
4 Place the wick wheel on the wick
support (g m).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
5 Place the water tray back into the
appliance (g n).
6 Turn the top cap of the water tank
anti-clockwise to unscrew it
(g o).
7 Fill the water tank with cold tap
water (g p).
8 Turn the top cap clockwise to tightly
lock it onto the water tank (g q).
9 Place the water tank back into the
appliance (g r).
3 Get started
Installing the
NanoProtect lter
The appliance comes with the
NanoProtect lter tted inside. Remove
the packaging of the lter before using
the appliance place it back into the
appliance described as follows:
Note
• Make sure that the side with the tag
is pointing towards you.
1 Pull the top part of the back panel
towards you to release it from the
appliance (g c).
2 Press the two clips down and pull
the pre-lter towards you (g d).
3 Remove the NanoProtect lter from
the appliance (g e).
4 Remove all packaging materials of
the NanoProtect lter (g f).
5 Place the NanoProtect lter back
into the appliance (g g).
6 Put the pre-lter back into the
appliance, mount the pre-lter onto
the bottom of the appliance rst,
and then push the clips on the top
of pre-lter against the appliance
(g h).
7 To reattach the back cover, mount
the panel onto the bottom of the
appliance rst, and then push
the top of the panel against the
appliance (g i).