Philips AC4236 - Adjusting Air Purifier Modes

9EN
English
» After measuring the air quality, the air purier automatically switches
to the display which has the highest readings among PM2�5, IAI and
Gas (g h)�
3 Touch and hold the button for 3 seconds to switch o the air purier�
Note: If the air purier stays connected to the electrical outlet after turning
OFF, the air purier will operate under the previous settings when turned ON
again�
Changing the mode setting
You can choose Auto mode, Turbo mode or the Sleep mode by touching the
button� Touch the button once to display the current mode�
Auto mode ( ): In Auto mode, the dual-sensor sense the air quality in real-
time and the appliance automatically adjusts the fan speed in accordance
with the ambient air quality, the control panel can automatically adjust display
screen brightness according to the ambient light� (g i)�
Turbo mode ( ): In Turbo mode, the air purier operates on the highest
speed (g j)�
Sleep mode ( ): In Sleep mode, the air purier operates quietly at a low
speed� After 3 seconds, the screen dims (g k)�
Switching the display indicator
Note:
• The IAI level is displayed on the central of the screen by default�
1 Touch the button once to switch the display indicator (g l)�
2 Touch and hold the button for 3 seconds to check the explaination of
IAI/Gas/ PM2�5 level (g m)�
Using the light on/o function
With the light sensor, the control panel can automatically turn on, turn o or
dim according to the ambient light� The control panel will be o or dim when the
ambient light is dark� You can touch any button to wake up all lights� Then, if no
further operation, all lights will be o or dim again to match with the ambient
light (g n)�
You can touch the light on/o button manually to turn o all lights and the
control pa nel� Touch any button to wake up all lights (g o)�