Philips AC4236 - Operating Your Philips Air Purifier; Understanding Air Quality Indicators

7EN
English
Note:
• This instruction is only valid when the air purier is being set up for the rst
time� If the network has changed or the setup needs to be performed again,
see Chapter "Reset the Wi-Fi connection" on page 7�
• If you want to connect more than one air purier to your smartphone or
tablet, you have to do this one by one�
• Make sure that the distance between your smartphone or tablet and the air
purier is less than 10 m without any obstructions�
• This App supports the latest versions of Android and iOS� Please check
www�philips�com/purier-compatibility for the latest update of supported
operating systems and devices�
Reset the Wi-Fi connection
Note:
• Reset the Wi-Fi connection when your default network has changed�
1 Put the plug of the air purier in the power socket and touch to turn on
the air purier�
2 Touch and simultaneously for 3 seconds until you hear a beep�
» The air purier goes to pairing mode�
» The Wi-Fi indicator blinks orange�
3 Follow the steps 3-4 in "Setting up the Wi-Fi connection for the rst time"
section�
4 Using the air purifier
Understanding the air quality light
The air quality light automatically
goes on when the air purier is
switched on, and lights up all colors
in sequence� After approximately
30 seconds, the particle sensor
selects the color that corresponds to
the surrounding air quality of airborne
particles�
The color of the air quality light is determined by the highest risk index among
PM2�5, IAI and Gas readings�
Air quality light color Air quality level
Blue Good
Blue-purple Fair
Purple-red Poor
Red Very poor