Philips AC4372 - Page 14

14EN
4 Use a vacuum cleaner or wash the pre-
lter under a running tap. If the pre-lter is
very dirty, use a soft brush to brush away
the dust.
5 Air dry the pre-lter.
6 Put the pre-lter back into the purier.
Attach all hooks properly to the purier.
2
1
7 To reattach the front panel, insert the
bottom hooks into the bottom of the
purier rst (1). Then, push the panel
against the body of the purier (2).
8 Plug the air purier into the power socket
and press the
button to switch on the
purier.
9 Press and hold the button for 3
seconds to reset the lter lifetime.
»
go off.
3s
Note
•
Make sure that the pre-lter is completely dry. If it is still
wet, bacteria may multiply in it and shorten the lifetime
of the pre-lter.
• Make sure that the side with the two projections is
pointing towards you, and that all hooks of the pre-lter
are properly attached to the purier.