Philips AC4372 - Using Your Air Purifier; Operating the Air Purifier On and Off

9
EN
4 Use the air
purifier
Understand the air quality
light
Color of the air quality
light
Air quality level
Blue Very good
Dark purple good
Purple fair
Red bad
The air quality light automatically goes on when
the purier is switched on.
Note
•
The built-in air quality sensor measures the air quality
and automatically selects the appropriate color of
the air quality light. When the air is clean, the color
of the air quality light is in blue. When the air quality
deteriorates, the color of the air quality light changes
from dark purple to red.
Switch on
1
Plug the air purier into the power socket.
» All lights go on from left to right in
cycle, and you hear a beep. Then, the
lights go out again.
» The air quality light shows its 4 colors .
2 Press the button to switch on the
purier.
» The fan speed indicators
(AUTO) and
goes on.
Note
•
When the purier is switched on, the air quality sensor
will take some time to measure the air quality in the room.
The air quality light changes its color and eventually stays in
the correct color in accordance with the air quality..
3 Press and hold the button for 2
seconds to switch off the purier.
2”
Tip
•
The purier has a memory mode. It will recall the
previous settings of your last use.
• If you disconnect the purier from the power supply
after switching off, it will enter the default mode for
next use. The fan speed is
(AUTO).