Philips AC4372 - Getting Started; Installing Air Purifier Filters

7
EN
3 Get started
Installlters
The appliance comes with all lters tted
inside, but you have to remove the packaging
of the lters before you can use the appliance.
Remove all lters, unpack them, and place them
back into the appliance as described below.
Note
•
Insert the lters in the correct position.
1 Place your ngers in the recesses of the
side panels and gently pull the top part of
the front panel towards you.
2 Lift the hooks at the bottom of the panel
out of the bottom of the appliance.
3 To remove the pre-lter, grab the two
projections and pull the lter towards you.
4 Remove all the lters from the appliance.
5 Remove all packaging material from the
lters.
6 For AC4372, put the HEPA lter, activated
carbon lter and multi-care lter back into
the purier.