First time use
•
around the dispenser. If there is any strange noise, burnt smell or smoke
coming out from the product, please disconnect the power cord
above.
•
•
causing the water in the pure water jug appears white and cloudy. This is a normal phenomenon.
• In order to avoid dry-heating and protect the machine, please extract some ambient water before
extracting hot water.
•
is done and extracting water at 100
and the boiling point calibration will be completed automatically. This procedure will last for
60 seconds. A container with a volume not less than 500ml should be placed under the nozzle
during this procedure.
Note: Steam might be ejected during automatic boiling point calibration, please be aware of burn
hazards.
Safety lock
• Safety lock and temperature memory enabled mode: The machine will
memorize the last selected water temperature preset, unlocking is required
temperature memory enabled mode is the default factory setting.
• Press the safety lock key for 10 seconds to disable the safety lock and
temperature memory. The temperature selection will return to “ambient”
after 10 seconds automatically. Press the safety lock key for 10 seconds to
enable the safety lock and temperature memory again.
6. Usage instructions
05
To Next Page
Loading...
