Philips AJB4300 - Additional Features; Setting and Managing Alarms; Using Snooze and Sleep Timers

12 EN
7 Other features
Set alarm timer
Set alarm
You can set two alarms to ring at different time.
Note
• Make sure that the clock is set correctly.
1 In standby mode, press and hold /
for two seconds to activate alarm setting
mode.
» The hour and minute digits and /
begin to blink.
2 Press + TUNING/ HR - to set the hour.
3 Press + PRESET/ MIN - to set the minute.
4 Press / toconrm.
5 Press + TUNING/ HR - to select an alarm
source: buzzer, DAB, or FM.
• If you select buzzer as alarm source,
press / oncetoconrmthe
setting.
• If you select DAB or FM as alarm
source, press / twicetoconrm
the setting.
Tip
• When alarm sounds, volume increases gradually. You
cannot adjust the alarm volume manually.
Activate/deactivate alarm timer
• Press or repeatedly to activate or
deactivate the alarm timer.
» If the alarm timer is activated, [Alarm
1:On] or [Alarm 2:On] is displayed.
» If the alarm timer is deactivated,
[Alarm 1:Off] or [Alarm 2:Off] is
displayed.
• To stop the alarm, press the
corresponding or .
» The alarm repeats ringing for the next
day.
Snooze the alarm
• When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing
nine minutes later.
Set sleep timer
This radio can switch to standby mode
automatically after a preset period.
• Press repeatedly to select the sleep
timer period (in minutes).
» When the sleep timer is activated,
appears.
To deactivate the sleep timer:
• Press repeatedly until [Sleep off] (sleep
off) is displayed.