Philips AVENT Premium Plus - Page 12

12
English
Charging the breast pump
Fully charge the battery before you use the breast pump for the rst time and when the battery is low. Fully charging the
battery takes up to 4 hours.
1. Switch o the device. 2. Insert the adapter into
the wall socket and insert
the small plug at the other
end into the motor unit.
3. The battery is charging. 4. When the battery is
fully charged, remove
the adapter from the wall
socket and pull the small
plug out of the motor unit.
Battery indicator light description
All lights are steady
on. The battery is
fully charged.Charged
battery operates
approximately
3 pumping sessions.*
Two lights are steady
on.The battery is
charged suciently
for maximum two
sessions.*
First light ashes
slowly.The battery is
charged suciently
for maximum one
session.*
First light ashes
quickly.The battery
is very low, the
device will soon stop
operating, charging is
needed.
Battery lights light up
one by one and go
out all together.The
battery is charging.
* One session is the equivalent of 15 minutes (double electric breast pump) or 30 minutes (single electric breast pump).
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling them, they can be very
hot. To prevent burns, only start assembling the breast pump when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast pump parts and
breasts to prevent contamination. Avoid touching the inside of containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the breast pump to form
a proper vacuum.
3 sec.