- 29 -
Environmental information
All unnecessary packaging has been omitted� We have tried to make
the packaging easy to separate into two materials: cardboard (box and
polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company� Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment�
Remove the integrated battery
Note: We strongly advise you to have a professional remove the
rechargeable battery�
Only remove the rechargeable battery when you discard the appliance�
Make sure the battery is completely empty when you remove it� Only the
parent unit includes a battery�
Procedure:
1 Remove the 2 rubber feet at the bottom of the parent unit�
2 Remove the 2 screws that are now visible at the bottom of the parent
unit�
3 Put the antenna in upward position and remove the screw in the back
housing that is now visible�
4 Remove the back housing from the front housing by forcing a
screwdriver in between them� For newer versions manufactured after
August 2020*, there are 2 more screws underneath the rating label.
Tear out the rating label, remove the screws, release the belt clip and
slide open the battery compartment door�
5 Disconnect the battery connector cable (black-white-red cable)�
6 Remove the 4 screws from the battery holder� No screws for new
versions manufactured after August 2020�
7 Remove the battery�
*The production date code DDMMYY is located underneath the belt clip,
above the 2 rubber feet�
If there is no collection/recycling system for electronic products in your
country, you can protect the environment by removing and recycling the
battery before disposing the product�
Make sure the product is disconnected from the charging case before
removing the battery�
Warranty and support
If you need information or support, please visit www.philips.com/
support or read the international warranty leaet.
To Next Page