- 19 -
Problem Solution
The breast pump
does not work.
• Make sure the pump is correctly assembled and press the power
button to switch on.
• Make sure the power adaptor is correctly connected.
The display ashes
and then shuts
down automatically.
• When using the power adapter to supply power, make sure
you are using the one Philips provided. Then make sure it is
connected correctly, and then switch on the pump again.
• After checking the 2 scenarios above, if the problem persists,
contact Philips Consumer Care center for help
• If the timer on the display is more than 99 minutes (when it
comes to 100 minutes), the appliance will ash twice and shut
down automatically. If you need to continue using it, restart the
breast pump.
The silicone tube
connector is too
loose when it is
plugged into the
pump motor or
silicone cap.
• Change a new silicone tube connector.
The display shows
error cocde E1, the
breast pump stops
working.
• E1 means that the input voltage of the power supply you are
using is too high. Please make sure you use the power adapter
provided by Philips to ensure safe use.
The display shows
error cocde E2, the
breast pump stops
working.
• E2 means that the input voltage of the power supply you are
using is too low or the rated current of the power supply is too
small, the machine cannot start normally. Please make sure you
use the power adapter provided by Philips to ensure safe use.
To Next Page
Loading...
